Festo Introduces Ball Valve Assembly Program

May 19, 2014
The new program is designed to provide consistency across multiple plant locations.

Festo has introduced a ball valve assembly program designed to deliver a host of process application benefits across multiple plant locations. Festo now assembles, warrants and supports ready-to-install ball valve assemblies that can include the ball valve, Namur solenoid, actuator, positioner and sensor. The new Festo program ensures consistency, especially for the components that allow precise control of the ball valve – Namur solenoid, actuator, positioner and sensor.

“We found Festo would streamline operations and improve process control by assembling and supporting ball valve assemblies that had consistency in the actuation, communication, and sensing parts of the assembly,” says Craig Correia, Process Automation Industry Manager for Festo.

All the components in the Festo program meet ISO Namur and VDE standards. Festo can include, at a customer’s request, non-Festo components that meet international standards.

Festo has identified the following ball valves and components as part of the new ball valve assembly program:

  • VAPB-2F: The basic ball valve, preassembled with a quarter turn actuator. The stainless steel valve is a two-piece design so one of the threaded end caps can rotate to make it easier to install.
  • VAPB-3F: Identical to the VAPB-2F except that the VAPB-3F is a three-piece design. The end caps of the VAPB-3F are held on by through rods. Customers can completely remove the end caps for threading onto pipe. Customers can also remove the valve for service and leave the threaded end caps on the pipe.
  • VAPB-7F: This FDA compliant sanitary three-piece design version of the VAPB-3F comes with welded ends (or clamp) instead of threads.  The valve has a 20Ra internal surface finish. It also comes pre-assembled with a quarter turn actuator.
  • VZBA-4F-L/T: A three-way valve that has three ports and any combination of flow paths – L, T, and Shut.
  • DFPB: The Festo rack and pinion quarter turn actuator included in the above assemblies. Both double acting and single acting products are available.
  • SRBF: This simple, economical sensor box with metal body senses both the open and closed position of the valves.
  • CMSX: A new positioner from Festo that gives the customer analog control of a ball valve. A single part number will accept 0-10V, 4-20mA, or 0-20mA signals and control the position of the ball. This unit has a good price point, particularly because it has so many features. It also offers the customer analog output for verification of actual ball valve position. The CMSX does not consume air when at rest – an energy savings feature not typically found in pneumatic positioners.
  • NVF3: Standard 5/2 and 3/2 single solenoid Namur valve for local control of the ball valve assemblies. The solenoid bolts directly to Namur port on the Festo DFPB actuator. There is no need for tubing or fittings.

For more information, visit: www.Festo.com

Sponsored Recommendations

Heat Recovery: Turning Air Compressors into an Energy Source

More than just providing plant air, they're also a useful source of heat, energy savings, and sustainable operations.

Controls for Industrial Compressed Air Systems

Master controllers leverage the advantages of each type of compressor control and take air system operations and efficiency to new heights.

Discover Your Savings Potential with the Kaeser Toolbox

Discover your compressed air station savings potential today with our toolbox full of calculators that will help you determine how you can optimize your system!

The Art of Dryer Sizing

Read how to size compressed air dryers with these tips and simple calculations and correction factors from air system specialists.