OSHA & NFPA Compliant: Keeping Your Plant Safe
In March 2008, OSHA reissued its Combustible Dust National Emphasis Program (NEP) notifying approximately 30,000 companies nationwide that they will be targeted for inspections over the next few years. Mettler Toledo recognizes that many manufacturers are not up-to-date on the latest hazardous area compliance regulations or may not know that their industry is subject to those regulations. Don't wait until your facility receives a surprise visit from OSHA or worse yet, for a catastrophic incident to occur. Take the proactive approach to addressing the "hazardous area advisory level" in your facility.
Integrating Process Weighing Data
Efficient transfer of weighing process data to higher level PLC, MES or ERP systems makes manufacturing processes more efficient and more transparent. But identifying and implementing the most effective system for data transfer and integration can be challenging.
Mettler Toledo LLC
Level measurement of bulk solids and powders
This 26-page white paper from Monitor Technologies discusses the difficulties in measuring bulk solids and powders in bins, silos and hoppers. Download this document to learn which technologies are out there that can make this job easier.
Fired Up: Combustible Dust Raises Explosive Issues
Combustible dust fires happen in plants everyday. This white paper helps manufacturers learn more about combustible dust hazards and ways to handle combustible dust in your manufacturing plant in order to comply with OSHA's NEP. Learn more about choosing the right cleaning tools for your facility.
Nilfisk Industrial Vacuums
Drying Compressed Air in Hazardous Atmospheres
Hazardous locations have or could potentially have high concentrations of flammable gases, vapors, combustible dusts, etc. A small spark can lead to a horrific explosion dangerous to equipment and workers in the area. Equipment located in hazardous areas must be specifically designed to prevent ignition and explosion.
Aseptic PAT and Particle Monitoring
In this white paper, Mark Hallworth, pharmaceutical manager for Particle Measuring Systems, discusses continuous monitoring methods, how theyre evolving, and why theyre important.
Particle Measuring Systems
Mixing of Powders into Liquids – Dust-free Induction and Dispersion
Mixing of powders into liquids should be relatively easy. You pour powder onto the liquid's surface and then mix it in. However, this mixing can be very troublesome in production. This paper examines the various factors involved with mixing powders into liquids and how to avoid potential problems.
Powder Technologies, Inc.
Hygienic Feeder Design
Specifying a hygienic bulk solids feeder is not a simple task. The wide variety of requirements needed
for specific applications are similar in scope to explosion proof environmental requirement variations.
Tips for Improving the Performance of Your Gravimetric Feeder
Download the white paper to receive information on maximizing the performance of your gravimetric feeder. You will receive tips on how to choose and set up the right feeder for the specific material being fed in your process. Handling free flowing, adhesive, cohesive, aeratable, hygroscopic and pressure sensitive materials plus ways on where and how to properly install a gravimetric feeder are discussed.
Rectifier design for fuel ethanol plants reduces energy
Plants have traditionally used trays in the distillation columns to produce fuels grade ethanol. Trays of various configurations have been adequate in this service and their technology is well founded. The ever-present desire to reduce the energy needed to produce a gallon of ethanol has opened the doors to structured packings being used in the rectification sections of ethanol distillation columns.