Design Considerations for High Liquid Rate Tray Applications
Except for a few odd services, high liquid rate applications are typically the domain of either trays or random packings. Aside from the distributors, random packing designs are rather straightforward with the designer choosing the proper size to accommodate the fluid flow rates and achieve the desired efficiency. Trays, on the other hand, have a large variety of adjustable parameters and can be especially complex, especially when designed for high liquid rate applications.
Sulzer Chemtech USA, Inc.
Pitfalls of pump piping
This white paper goes over the three major problems associated with poor pump piping and provides five rules to follow in order to avoid future pitfalls.
Ross Mackay Associates Ltd.
Oxygen in cell culture/venting ozonated vessels
This white paper outlines trends and opportunities for gasket standardization in processing plants ... including the potential for more reliable sealing, cost savings, inventory reduction, easier installation and safety practices. Steps are outlined for achieving success in gasket standardization across steel, glass-lined and FRP piping.
Design Tips for Sensing Probes
This application note from Delta Controls outlines selection and installation criteria for using admittance probes to monitor the level of powders, liquids and other materials. Dielectric constants of more than 200 materials are included.
Accurate liquid phase density on aerated liquids
This white paper discusses SONAR-based, clamp-on gas volume fraction meters which recently have been introduced to the industry that provide an accurate, real time, measurement of entrained gases. Coupling entrained gas volume fraction monitor with most types of process density meters, enables accurate determination of liquid and the liquid-solid components of aerated mixtures.
Electro-hydraulic system design: Making the right system choices
Designers who understand and can take advantage of the differences between fluid power and traditional electromechanical power can build machines that produce higher quality output with lower lifecycle costs. This white paper suggests that care must be taken, however, in selecting and sizing the hydraulic system elements and in tuning the motion controller for optimal performance.
Delta Computer Systems
Technology expands flowmeter capabilities, reduces costs
Capacitance-type magnetic flowmeters have traditionally offered the advantage of having non-wetted electrodes and the ability to measure low conductivity fluids. However, they suffered from a sensitivity to flow noise and zero instability. Innovative technology overcomes these limitations and drives magnetic flowmeters into new areas of application, while reducing installed costs.
Bearing isolators 101
A bearing isolator is a non-contact, non-wearing, permanent bearing protection device. It has a rotor and a stator, and the two are unitized, so that they dont separate from one another while in use. Typically, the rotor turns with a rotating shaft, while the stator is pressed into a bearing housing. The two components interact to keep contamination out of the bearing enclosure and the lubricant in.