Technology expands flowmeter capabilities, reduces costs
Capacitance-type magnetic flowmeters have traditionally offered the advantage of having non-wetted electrodes and the ability to measure low conductivity fluids. However, they suffered from a sensitivity to flow noise and zero instability. Innovative technology overcomes these limitations and drives magnetic flowmeters into new areas of application, while reducing installed costs.
Bearing isolators 101
A bearing isolator is a non-contact, non-wearing, permanent bearing protection device. It has a rotor and a stator, and the two are unitized, so that they dont separate from one another while in use. Typically, the rotor turns with a rotating shaft, while the stator is pressed into a bearing housing. The two components interact to keep contamination out of the bearing enclosure and the lubricant in.
Fisher control valve handbook
This 295-page PDF whitepaper is a control valve resource that has been consistently updated for 30 years. It contains vital information on control valve performance and latest technologies.
How to control a process with long dead time
A process with a large dead time presents a special challenge for a controller -- any controller. This short paper explains how to get the best control of large dead time processes.
Theory and practice of pH measurement
This 43-page guide covers the basic mechanism of pH measurement, the structure of the sensor and its fundamental limitations, and also provides installation, maintenance and troubleshooting guidance.
Level measurement of bulk solids and powders
This 26-page white paper from Monitor Technologies discusses the difficulties in measuring bulk solids and powders in bins, silos and hoppers. Download this document to learn which technologies are out there that can make this job easier.
Tracing the accuracy of calibration gases
Calibrating your instruments using specialty gas will only yield results as accurate as your gas mixture. This three-page white paper discusses analytic traceability and how it relates to gas mixture accuracy.
Ziegler-Nichols Tuning Rules And Limitations
The standard reference for PID tuning seems to be the Ziegler-Nichols tuning rules developed in 1942 on a pneumatic controller. Here is how to tune a controller using these rules.
Understand Pump Lifecycle Costs
This 22-page paper from the Dept. of Energy, Hydraulic Institute and Europump explains the importance of understanding the total costs of ownership to achieve savings in energy, and operational and maintenance costs. It discusses what lifecycle cost is, what should be considered in a lifecycle cost analysis, and the role of proper pump system design.
Achieve 21 CFR Part 11 Compliance
This technical white paper discusses Yokogawas CENTUM CS 3000 R3 DCS (Distributed Control System) product and the extent of its compliance with Part 11 of Title 21 of the Code of Federal Regulations (21 CFR Part 11), the Electronic Records/Electronic Signatures Rule.
Design the Heat-Transfer-System Expansion Tank Right
The design of the expansion tank plays an important role in the successful operation of a heat transfer system using organic fluids. It can contribute to longer fluid life and lower maintenance. This paper describes the proper sizing, piping and valving, instrumenting, and inerting of the tank.
Succeed at Alarm Management
Today's control system make it easy to add alarms. The result has been a proliferation of alarms that can overwhelm an operator and actually obscure situations that really require immediate attention. This paper provides practical guidance on effective procedures that can significantly reduce nuisance alarms and improve operator effectiveness.
D. Shook, PhD, P.Eng., Matrikon, Inc.
Selecting Transmitters for Safety Instrumented Systems
This paper presents best practices that allow the user to quantify the impact of real-world failure causes and to take credit for improvements in system design. Besides selection, it also covers installation and maintenance.