Process Engineering White Papers

241-260 of 340 < first | | | last >
  • Process Control Network Security

    This document provides an understanding of intrusion detection and prevention systems, why they are necessary, how and where they fit in the control system environment, and gives example scenarios.

  • V-Cone flow meter test results | Chemical Processing

    The American Petroleum Institute Manual of Petroleum Measurement Standards published the results of flow meter tests at the Southwest Research Institute and Utah State University.

    Southwest Research Institute
  • Use CFD to Improve Crystallization | Chemical Processing

    In this article, Kumar Dhanasekharan, Ph.D., technical specialist with the computational fluid dynamics (CFD) specialist Fluent, Inc., shows how modelling crystallizers using CFD can help improve process understanding, control crystal size distribution (CSD) and improve pharmaceutical crystallization results.

  • Fieldbus and remote I/O system comparison

    Nine manufacturers participated in the FuRIOS study, which was conduced under the lead of an end user company that compared its use of fieldbus and remote I/O in full detail.

    Aventis, Infraserv GmbH
  • Aseptic PAT and Particle Monitoring

    In this white paper, Mark Hallworth, pharmaceutical manager for Particle Measuring Systems, discusses continuous monitoring methods, how they’re evolving, and why they’re important.

    Particle Measuring Systems
  • The Regional Transport of Ozone

    EPA tracks emissions of six principal air pollutants - carbon monoxide, lead, nitrogen oxides, particulate matter, sulfur dioxide, and volatile organic compounds. All have decreased significantly since passage of the Clean Air Act in 1970 - except for nitrogen oxides.

  • Process Control Network Security - Reference Architecture

    This document describes best practices for the reference architecture for a process control system network and its interfaces to a corporate network. The paper’s objective is to give the reader an understanding of the techniques utilized to securely connect these networks.

  • Design Tips for Sensing Probes

    This application note from Delta Controls outlines selection and installation criteria for using admittance probes to monitor the level of powders, liquids and other materials. Dielectric constants of more than 200 materials are included.

    Delta Controls
  • Clean Compressed Air

    Good air preparation should consider the energy consumption of the system and air treatment equipment.

  • Continuous imaging fluid particle analysis: A Primer

    This paper looks at the issues associated with fluid particle analysis, discusses some of the historical methods used, and introduces a new technology: the continuous imaging fluid particle analyzer.

    Fluid Imaging Technologies
  • Accurate liquid phase density on aerated liquids

    This white paper discusses SONAR-based, clamp-on gas volume fraction meters which recently have been introduced to the industry that provide an accurate, real time, measurement of entrained gases. Coupling entrained gas volume fraction monitor with most types of process density meters, enables accurate determination of liquid and the liquid-solid components of aerated mixtures.

  • Specifying industrial fieldbus networks for automation

    Automation designers face many challenges and tradeoffs in the development of a successful network solution. This white paper discusses the necessary choices in selecting a network technology appropriate for various specific applications.

    Texas Instruments
  • Measurement Best Practices

    This 9-page PDF discusses way in which you can ensure your measurements are accurate, repeatable and reliable.

  • Energy Efficiency - The Other Alternative Fuel

    Proven methods for industry to reduce energy consumption and environmental impact are already at hand. These cost-effective solutions promise substantial return-on-investment now and in the future, without sacrificing performance or quality. For most companies and organizations, the answers to maintaining a competitive edge in this era of rising energy costs are readily available. By applying a suite of cost-effective power and automation solutions from technology leaders like ABB, these facilities can achieve substantial energy savings today without waiting for the "alternative fuels" of the future.

  • Securing Process Control Network External Communications

    In the real world, sharing PCN data with external systems and accessing PCN systems from external sources is fast becoming a business necessity. This paper provides some generic guidelines for enabling secure connectivity between PCNs and external systems.

241-260 of 340 < first | | | last >