This document describes best practices for the reference architecture for a process control system network and its interfaces to a corporate network. The papers objective is to give the reader an understanding of the techniques utilized to securely connect these networks.
Advanced diagnostics, some of which are available today, will go beyond alarming transmitter
failures to actually predict impending failures in the complete measurement system. This will
significantly reduce unscheduled shutdowns, and also reduce the risk of onscale failure.
This white paper discusses SONAR-based, clamp-on gas volume fraction meters which recently have been introduced to the industry that provide an accurate, real time, measurement of entrained gases. Coupling entrained gas volume fraction monitor with most types of process density meters, enables accurate determination of liquid and the liquid-solid components of aerated mixtures.
Automation designers face many challenges and tradeoffs in the development of a successful network solution. This white paper discusses the necessary choices in selecting a network technology appropriate for various specific applications.
Designers who understand and can take advantage of the differences between fluid power and traditional electromechanical power can build machines that produce higher quality output with lower lifecycle costs. This white paper suggests that care must be taken, however, in selecting and sizing the hydraulic system elements and in tuning the motion controller for optimal performance.
Capacitance-type magnetic flowmeters have traditionally offered the advantage of having non-wetted electrodes and the ability to measure low conductivity fluids. However, they suffered from a sensitivity to flow noise and zero instability. Innovative technology overcomes these limitations and drives magnetic flowmeters into new areas of application, while reducing installed costs.
A bearing isolator is a non-contact, non-wearing, permanent bearing protection device. It has a rotor and a stator, and the two are unitized, so that they dont separate from one another while in use. Typically, the rotor turns with a rotating shaft, while the stator is pressed into a bearing housing. The two components interact to keep contamination out of the bearing enclosure and the lubricant in.
This eight-page PDF whitepaper discusses the importance of transmitter selection for centrifugal compressors. Appropriate selection is especially important in anti-surge and throughput control applications.