Perspectives: Plant InSites

Distillation Guidelines: Draw Some Important Lessons

Measuring liquid level on a column draw tray demands care

By ANDREW SLOLEY, Contributing Editor

One way to measure liquid flow inside a distillation tower is to infer the flow rate from a liquid level. Figure 1 shows a typical installation. A partial side draw takes a product from a sump on a draw tray while the remaining liquid overflows a weir and continues down the tower. The level measured on the draw tray goes to the plant’s advanced control system, which uses the value in calculating the internal liquid flow rate. In this case, the purpose of obtaining the internal liquid rate was to ensure the trays below the liquid draw had sufficient liquid for proper operation. Trays have a mechanical limit on liquid rates. Below that limit, efficiency may drop dramatically. The tray type and geometry as well as the physical properties of the system determine the minimum acceptable liquid rate. The plant found controlling the distillation specifications of the side-product draw extremely difficult. Purity, especially of heavy components, would vary dramatically for the same calculated liquid internal rate. (Sudden spikes in heavy components in the side draw are strong signals that the internal liquid rate is too low.)

Read more

More from this perspective...


Odd Layout May Make Even More Sense

Unusual tower configuration better copes with control valve failure.


Heat Exchangers: Is Mist a Must?

Water sprays may boost performance of air-fin exchangers.


Is Your Vessel Foundation Really Strong Enough?

Certain situations can lead to exceeding design limits.


Backflush Away Fouling

Flow reversal can remove fiber buildup in heat exchangers.


Properly Position Interlock Valves

The obvious location may not be the most cost effective


Piping Geometry: Grasp Line Layout

Draining, venting, fouling and other considerations affect piping geometry.


Consider Compact Reboilers

Several types of heat exchangers can save space


Select the Right Reboiler

Understand the strengths and weaknesses of various options.


Get Your Head Around Velocity Head

Confusion about what the term means can spell trouble.


Old Doesn't Mean Outdated

Some equations have stood the test of time.


Vacuum System Fix Fizzles

Use of scavenged equipment leads to problems.


More Exchanger Area Can Pose Pitfalls

This "obvious solution" for heat-transfer problems may not work.


Do Liquid Injection Right

A variety of factors influence performance.


Let the Buyer Beware

Understand common dangers when developing specifications and evaluating bids.


Tackle Tray Trade-Offs

Find the right compromise between process and mechanical requirements.


Watch Out For Dead-Legs

Lack of flow doesn't mean lack of problems.


Distill Your Internals Choice

Some general guidelines can ease the selection process.


Take a Different Look at Centrifugal Pumps

An unconventional assessment can provide insights for effective control.


Pick the Proper Centrifugal Pump

Consider the impact of startup conditions and prospective operating points.


Don't Calculate Pressure Drops in a Vacuum

Consider flow regime boundaries and the limitations of methods.