Perspectives: Plant InSites

Distillation Guidelines: Draw Some Important Lessons

Measuring liquid level on a column draw tray demands care

By ANDREW SLOLEY, Contributing Editor

One way to measure liquid flow inside a distillation tower is to infer the flow rate from a liquid level. Figure 1 shows a typical installation. A partial side draw takes a product from a sump on a draw tray while the remaining liquid overflows a weir and continues down the tower. The level measured on the draw tray goes to the plant’s advanced control system, which uses the value in calculating the internal liquid flow rate. In this case, the purpose of obtaining the internal liquid rate was to ensure the trays below the liquid draw had sufficient liquid for proper operation. Trays have a mechanical limit on liquid rates. Below that limit, efficiency may drop dramatically. The tray type and geometry as well as the physical properties of the system determine the minimum acceptable liquid rate. The plant found controlling the distillation specifications of the side-product draw extremely difficult. Purity, especially of heavy components, would vary dramatically for the same calculated liquid internal rate. (Sudden spikes in heavy components in the side draw are strong signals that the internal liquid rate is too low.)

Read more

More from this perspective...

Title

Is Your Vessel Foundation Really Strong Enough?

Certain situations can lead to exceeding design limits.

12/03/2012

Heat Exchangers: Is Mist a Must?

Water sprays may boost performance of air-fin exchangers.

01/02/2013

Odd Layout May Make Even More Sense

Unusual tower configuration better copes with control valve failure.

01/23/2013

Consider "Pasteurizing" Your Column

A side-draw may cut capital and energy costs for distillation.

02/12/2013

Effectively Remove Droplets

Various factors affect the choice and operation of liquid/vapor separators.

03/19/2013

Think Straight About Orifice Plates

Insufficient flow conditioning often undermines measurement accuracy.

05/21/2013

Put V-cone Meters on Your Short List

06/10/2013

Don't Let a Second Liquid Phase Faze You

07/16/2013

Baffles Needn't Be Baffling

Clear criteria determine their design for drums to separate three phases.

08/19/2013

Flow: Avoid Splitting Headaches

Ensuring proper control of parallel flow paths demands care.

09/12/2013

Shell-and-Tube Heat Exchanger

Allocating fluids in a tubular exchanger demands care.

10/23/2013

Head Off Heat Exchanger Errors

Selecting the most-appropriate heads for a shell-and-tube unit is crucial.

12/16/2013

Centrifugal Pumps: Avoid Surprises When Cutting Impellers

Predicting resulting centrifugal pump performance demands care

01/15/2014

Choose the Correct Condenser

Consider a variety of factors when selecting a unit.

02/10/2014

Workplace Training: Do Your Homework

Evaluate a variety of factors before embarking upon continuing education.

02/25/2014

Consider VFDs for Centrifugal Pumps

Such drives may provide energy savings and avoid operating problems.

03/12/2014

Centrifugal Pumps: Fight Flow Recirculation

But first understand why the phenomenon occurs in centrifugal pumps.

04/17/2014

Reliability and Maintenance: Don’t Slight Strainers

These simple but often essential devices deserve adequate attention

05/08/2014

Get Valid Samples

Materials’ selection and piping design markedly can affect results.

06/25/2014

Distillation Columns: Get Some Inside Information

A gravity-flow loop can enable measuring internal liquid flow in a column

07/22/2014