Perspectives: Energy Saver

Optimize Electrical Systems, Part II

Take a closer look at electric motors and plugged-in loads for potential energy savings.

By Ven V. Venkatesan, Energy Columnist

Improving motor efficiency is the most common opportunity to save electricity. Several factors can decrease motor efficiency: poor maintenance and lubrication, misalignment, frequent starting and stopping, and improper sizing. Under-sized motors draw excessive current to do the work and eventually fail due to overheating. Generally, motors are correctly sized, but if change in loading conditions makes the motor under-sized, it needs to be replaced with suitable-sized unit. Over-sized motors can draw more current than required for the work, wasting energy. In such a case, reducing the motor speed with a variable frequency drive could lower the power draw to deliver the same work. For correctly sized motors, installing ammeters would help to ensure the motor is not overloaded continuously.    Installing a variable frequency inverter on AC induction motor drives is the most common energy savings project to reduce electricity consumption, especially for plants operating a large number of centrifugal pumps and fans. In the normal plant design, most of these pumps and fans are coupled with discharge-side flow control valves to meet the exact process requirement. However, discharge-side valve or damper control is inefficient for fluid flow control. Varying the speed of the centrifugal pump or fan is much more efficient.

Read more

More from this perspective...

Title

Energy Saver -- Educate Your Peers

Train your technical specialist on energy efficiency.

07/07/2010

Train Your Operators on Energy Efficiency

Provide them with the right information and listen to their ideas.

08/09/2010

Train Your Project Manager on Energy Efficiency

Treating energy saving measures as project add-ons can help.

09/07/2010

Train Your Plant Manager on Energy Efficiency

Present your energy program in a way the plant manager can quickly comprehend.

10/20/2010

Know the Basics of Energy Management

Make energy management maintenance a routine part of your day.

11/22/2010

Take a Fresh Look at Your Process Heaters

A simple four-step program can lead to significant savings.

11/30/2010

Take a Fresh Look at Your Process Heaters -- Part 2

Three simple steps can help reduce stack temperature.

01/06/2011

Optimize Your Steam System, Part I

A simple four-step approach can improve steam efficiency.

02/02/2011

Optimize Your Steam System, Part II

A simple four-step process can improve steam efficiency.

03/07/2011

Optimize Heat Exchangers

Three parameters govern a heat exchanger's effectiveness.

04/14/2011

Optimize Your Compressed Air Systems

Five simple steps could improve air compressor efficiency

05/06/2011

Recover Low Level Heat, Part I

This two-part series highlights innovative concepts for recovering such heat

06/03/2011

Recover Low Level Heat, Part II

Additional innovative options exist to recover such heat

07/27/2011

Don’t Overwork Pumps and Fans, Part I

Four simple steps present opportunities to reduce energy use.

08/22/2011

Don't Overwork Pumps and Fans, Part II

Several opportunities exist to reduce a fan's energy use.

09/14/2011

Save Energy In Water Systems, Part I

Plants often miss opportunities to more fully use hot water.

10/13/2011

Save Energy in Water Systems, Part II

Recover cold cash from cooling water systems.

11/16/2011

Optimize Energy Costs, Part I

Several petrochemical examples highlight energy efficiency.

12/20/2011

Optimize Energy Costs, Part II

Alternative process heating methods could offer attractive pay-offs.

01/25/2012

Optimize Energy Costs in Petroleum Refineries, Part I

Improve refining margins with more energy efficient measures.

02/21/2012