Print page

Print page

How do I remove Bromium from water?

Q: What is the most adequate method for removing Bromate from the water other than reverse osmosis?

A:

First, I have to qualify the answer by indicating that you did not provide any additional information about the liquid in which the Bromium ion was dissolved, other than it was water.

Bromium can, depending upon pH, be stripped from water by aeration. That is the easiest and cheapest method. Depending upon the amount of Bromium in the air used for stripping, you can probably get the Bromium concentrations down to well under 0.1 mg/l, and possibly down to non-detect levels.

If you need to get the Bromium out with high assurance, try using silver or Mercury salts at the collection agent. The precipitation reaction with Silver is very good. (Ksp Hg2Br = 6 × 10^-23, sand the solubility with Silver is also very good: AgBr    0.000014 g/100 gm of water. (0.14 mg/l if I have correctly placed the decimal.)

If that's too expensive, consider hydroxyl ion exchange. That should replace the Bromium with OH ions and it will raise the pH.  It can be a part of a full deionization of the water, or just a part of an anion exchange column.  The advantage of an hydroxyl exchange resin is that you back wash it with Sodium hydroxide and get a fluid of NaBr out.

Here are more of the latest questions on: Environmental Protection

Can our calcium carbonate "waste" be utilized in other industries so we can divert it from landfills?
I work for a major sugar producer. As part of our process, calcium carbonate is created at a refinery that utilizes a process called carbonization for primary purification. In this process lime (calcium oxide or CaO) and carbon dioxide (CO₂) are proportionally added and a chemical reaction takes place. A calcium carbonate (CaCO₃) precipitate is formed as a result, which captures colorant between the CaCO₃ crystals and this is subsequently filtered out, desweetened, and partially dried.

Currently we dispose of millions of pounds of this calcium carbonate "waste" each year. We would like to know if this material can be utilized in other industries so we can divert it from landfills to be recycled. Please advise if you know of any outlets for this material. Analytic testing results can be provided if needed.

What is causing the gummy mess in the fermentation process?
We are facing a gummy fermented mash in our fermentation section using sugarcane molasses as feedstock. What is the reason of formation of gum in fermentation? How can we overcome the gum? Is there a method for determining the amount of the gum in mash?

What impact does ethanol have in the operation of the wastewater treatment plant?
I'm looking for information regarding refineries' experiences handling ethanol-gasoline vapors from truck loading racks in their flare system. Also, the impact ethanol has in the operation of the wastewater treatment plant. In some systems, these vapors will mix with water (in headers, FGR units, Flare KO drums, sour water stripping units, etc.) and will end up in wastewater units. What steps have been taken to manage this situation?

Could you recommend a good method for separating exhaust?
We have an exhaust stream that includes CH₄, CO₂, CO, H₂O. I want to separate CH₄ and reuse it in the furnace. Could you recommend a good method for separation?

Is there a better chemical to use as an anti-foaming agent?
We have a problem with excess foam generated in our primary rinse out conveyor. The rinser uses water to remove PVA film left over by a decorative film dipping process (water transfer printing).
We have tried an anti-foaming product with Polydimethylsiloxane, but we are still having to use far more than the recommended amount for the two 100-gallon tanks.
Is there a better chemical to use as an anti-foaming agent or can the foam be reduced mechanically?

Back to Ask the Experts