Guidance for chemical manufacturers, processors, and distributors about Section 8(e) of the Toxic Substances control act was issued on September 14, by the U.S. Environmental Protection Agency (EPA). Chemical Processing's Regulatory Editor Lynn Bergeson discusses the new regulation.
When it comes to selecting and sizing control valves and positioners, this article not only helps you pick the right one for the right job, but also includes a valuable valve selection chart you can download!
Some U.S. oil refineries repair their centrifugal pumps every three years while other refineries enjoy an average repair interval of 10 years. Learn about the highest-performing refineries and other petrochemical companies that have significantly reduced pump failures, and how you can obtain the same results.
While fermentation-based syntheses were once reserved for producing high-value specialty chemicals and biopharmaceuticals, bioprocess routes now are gaining increasing attention for commodity products.
Author: John L. Shaw, P.E., and Scott A. Rogers, P.E., CH2MHill Lockwood Greene
The Restrictions of the Use of Certain Hazardous Substances in Electrical and Electronic Equipment (the RoHS Directive) is part of a growing wave of European Union product-based regulations that will profoundly impact global and United States product standards and thus the chemical industry.
Because many environmental applications of nanotechnology will almost certainly revolutionize the science, law, and regulation of water pollution, readers are urged to keep abreast of this fast-changing area.
"Bad actor" pumps are those pumps that have trouble with frequent and repetitive failures. In many cases, the source of the problem is an ANSI pump trying valiantly to handle a liquid well beyond the range of its design rating.of 300 degs. F.