Articles

261-280 of 340 < first | | | last >
  • Increase pump performance

    In this web exclusive on ChemicalProcessing.com, pump expert Ross Mackay says a key to a pump's performance is to look at the control system it's running with.

    Ross Mackay
    09/18/2006
  • Pump Performance: Kayo Cavitation

    Checking pump performance curves is one of the first steps in troubleshooting a centrifugal pump problem or seeing if a pump can handle new service conditions. Learn to look for more than just insufficient NPSHA, the common culprit, when investigating cavitation.

    Andrew Sloley, contributing editor
    07/17/2006
  • Keep a steady eye on measurements

    While engineers often strive to keep processes running without too much variation, measurements that don’t change may be a cause for concern not celebration, as one refinery can attest.

    Andrew Sloley, contributing editor
    06/19/2006
  • Pumping Temperature Considerations

    "Bad actor" pumps are those pumps that have trouble with frequent and repetitive failures. In many cases, the source of the problem is an ANSI pump trying valiantly to handle a liquid well beyond the range of its design rating.of 300 degs. F.

    Ross Mackay
    06/19/2006
  • Mind Mixer Mechanical Design

    While most mixers can provide a long service life — for instance, some are still operating after more than 30 years — mechanical problems can shorten life or even break parts. In this article, learn about all the mechanical problems that may befall your mixing equipment.

    David S. Dickey, MixTech, Inc.
    04/18/2006
  • Find the real cause of pump gas up

    Simply blaming high feed temperature for inadequate suction isn’t enough when diagnosing pump problems. Read this article to get a laundry list of causes for pump gas up.

    Andrew Sloley, contributing editor
    04/17/2006
  • Bend Pressure Drop & Heat Transfer Performance

    The presence of bends and properly predicting pressure drop through them can have a significant impact on accurately estimating the thermal and hydraulic performance of the overall unit.

    LiDong Huang / Fernando J. Aguirre
    02/16/2006
  • Pump Start-Ups

    There are only three things we need to do to start a pump.

    Ross Mackay
    01/09/2006
  • Pumps benefit from a vane effort

    Widely used but underappreciated, back pump-out vanes extend bearings and seal life.

    Richard Nardone, ITT Industrial & BioPharm Group
    11/15/2005
  • pH linearization lubricates waste control

    Learn how a simplified technique for linearizing pH can enhance control in waste treatment applications and eliminate the need for gain-adjusting techniques.

    11/15/2005
  • Find the best value seal

    A new industry-developed tool provides insights and practical guidance on seal economics.

    Pete Petrunich
    10/18/2005
  • Flow Meter Focus

    ChemicalProcessing.com introduces Flow meter focus, a compilation of useful articles, news, white papers and product information related to flow meters.

    09/28/2005
  • Saving energy with fluid handling

    This article from Ross Mackay, an exclusive contributor to ChemicalProcessing.com and author of The Practical Pumping Handbook, discusses how you can save energy in your plant with proper pump selection.

    Ross Mackay
    09/20/2005
261-280 of 340 < first | | | last >