To make the most of diagnostic equipment used in chemical processing, technicians must stretch their knowledge of control valves and related diagnostic equipment that keeps tabs on valve health and safety.
Design provides improved reliability in a polymer-precursor batch reactor. Sensors must respond quickly and survive a harsh environment. Poor probe reliability can make the difference between a process that makes money and one that doesnt.
Control's Béla Lipták continues his series on control of distillation processes, this time focusing on managing reboiler flow, temperature, feed rate, loading and reflux for economy, stability and safety.
Senior Editor Dirk Willard discusses Shigeo Shingo's take on mistake-proofing, or Poke Yoke, if you speak Japanese. The practice suggests the following devices: eliminate redesign, facilitate guide, mitigate lessen the damage caused by the error, or flag identify the error.
Ignoring climate change could eventually damage economic growth, according to an authoritative report, says Mike Spear, editor at large, in this month's End Point column. Read more on the economics of climate change.
This article looks at six technologies mechanical floats and displacers, differential pressure, capacitance, ultrasonic, radar, and guided wave radar that are used most often for automated control, and provides practical guidance for choosing among them.
Author: Jerry Boisvert, Siemens Energy & Automation
Last months ISA Expo in Houston clearly showed how much attention wireless technology is attracting. However, concern about the reliability and life of batteries remains an issue. Thats why harvested or scavenged power is attracting interest.
Guidance for chemical manufacturers, processors, and distributors about Section 8(e) of the Toxic Substances control act was issued on September 14, by the U.S. Environmental Protection Agency (EPA). Chemical Processing's Regulatory Editor Lynn Bergeson discusses the new regulation.