Articles

41-60 of 67 < first | | | last >
  • Avoid blending blunders

    Selecting the correct device is crucial to successfully handling solids. It must deal with discrete pieces that have physical size, electrical properties, frictional differences and surface characteristics that can change with the environment.

    Tom Blackwood, Healthsite Associates
    09/04/2007
  • Equipment & Services: August

    Chemical Processing's Equipment & Services feature provides a variety of production equipment, supplier services and parts.

    08/22/2007
  • Equipment & Services: July

    Chemical Processing's Equipment & Services feature provides a variety of production equipment, supplier services and parts.

    07/24/2007
  • Optimize pump life cycle

    Understanding an operating system reduces costs and improves reliability. Getting the most out of your pump demands a well-thought-out, holistic strategy.

    Tom Carsten and Barry Erickson, Flowserve
    04/30/2007
  • Waylay weight woes

    Production managers, quality control managers and maintenance engineers alike have encountered weigh cells that never worked properly. Why? Why have so many switched from a supposedly high accuracy load cell solution to old fashioned level probes or sight glasses? This article touches on the worst culprits for problems and how to avoid them.

    Ryan Titmas, product manager, Sartorius North America
    01/08/2007
  • Avoid trouble with slurries

    Handling slurries (a mix of solids and liquids), should be based on experience and experiments, not theory. Much of the knowledge obtained from pneumatic conveyors and fluidization systems can be used in understanding slurries.

    Thomas R. Blackwood, Healthsite Associates
    11/01/2006
  • How to reduce caking problems

    This web-exclusive article from Diamondback Technology identifies the most common caking mechanisms and how to solve the problem through reduction.

    07/05/2005
  • Avoid confusion with air injection for fine powders

    Fine powders often need air injection to increase flow rates to an acceptable level. With entrained or injected air, powders flow like water, but when deaerated, the extremely low flow rate may be confused with a hang-up or arching condition.

    06/01/2005
  • Process manufacturing: No transfer required

    As the pharmaceutical industry has matured, concerns about the safe handling of drug compounds during the manufacturing process have increased. To meet exposure limits and protect batches from any kind of contamination, the industry’s need for improved containment has increased.

    Diane Dierking
    05/04/2005
  • Prevent fine powder flushing

    Trapped air can cause fine powders to shoot through cracks and crevices. Here's how to eliminate this bin-afflicting problem.

    Lee Dudley, Diamondback Technology
    02/06/2005
  • Properly introduce solids into a flowing gas stream

    Particulate solids are often required to be introduced into a flowing gas stream. If not done correctly, introduction of solids into the gas stream can lead to impingement of solids on the pipe, resulting in erosion of the pipe in the area of the solids introduction.

    01/31/2005
  • Take out torque

    A reader's ribbon blendor is experiencing torquing problems. Read tips about how to avoid torque problems in a ribbon blender.

    10/02/2004
41-60 of 67 < first | | | last >