Articles

181-200 of 243 < first | | | last >
  • Where is wireless going?

    Increasing interest will translate into far more monitoring applications. The worldwide market for wireless technology will grow 26% annually over the next few years, forecasts the ARC Advisory Group. Vendors are responding and key concerns are being addressed.

    Mike Spear, editor at large
    01/11/2007
  • Security poses an inherent industry dilemma

    Industry faces the threat of draconian demands from Congress as chemical plants remain an attractive targets for terrorism attacks, according to Mark Rosenzweig, editor in chief of Chemical Processing.

    Mark Rosenzweig, editor in chief
    09/21/2006
  • CAGI to verify compressor claims

    The compressed air industry is taking a step that will clear the air about the performance of its equipment. For the first time, many compressed air equipment manufacturers will submit their 50 hp to 200 hp lubricated rotary-screw compressors and 200 cfm to 1,000 cfm refrigerated air dryers to an independent laboratory for performance testing.

    Ken Byrd
    09/11/2006
  • The rise and fall of modulation

    Why have reciprocating designs fallen out of favor relative to the rotary compressor that is so predominant today? Read about the evolution of efficient controls for compressed air systems.

    Henry Kemp
    09/11/2006
  • Energy savings are often disguised as problems

    Carefully managing compressed air can save money. Compressed air is often overlooked in energy studies because many people do not fully understand compressed air equipment, their own system, or what it costs to produce compressed air power.

    Scott Van Ormer and Don Van Ormer, senior application engineers, Air Power USA
    08/18/2006
  • Can we keep pace with computers?

    The roll-out of 64-bit operating systems may necessitate taking stock of what we have.

    Mike Spear, editor at large
    08/18/2006
  • 2006 Readers' Choice Survey

    The equipment, services and suppliers selected to make a job easier greatly contribute to on-the-job success. The Readers' Choice survey identifies the leading vendors in more than 40 categories.

    Ken Schnepf, managing editor
    08/17/2006
  • Small sensors promise big impact

    Because many environmental applications of nanotechnology will almost certainly revolutionize the science, law, and regulation of water pollution, readers are urged to keep abreast of this fast-changing area.

    Lynn Bergeson, regulatory editor
    06/28/2006
  • Nanotechnology raises big concerns

    Nanotechnology is grabbing headlines these days and the growing prospects of its use is spurring increasing attention to safety issues. This article examines the worldwide reaction to burgeoning popularity of the technology and what safety concerns are legit.

    Mike Spear, editor at large
    05/25/2006
  • Develop an air-tight defense

    Chemical processors face significant challenges in controlling fugitive emissions. The emissions escape from valves, compressors, pumps, piping components, etc. It is a difficult task, but necessary to avoid penalties and other liability.

    Lynn Bergeson, regulatory editor
    04/24/2006
  • Nanotechnology readies for a wastewater role

    The federal government strongly backs development of nanotechnology, seeking to ensure that the United States leads the way in developing and commercializing appropriate applications.

    06/27/2005
  • Applying the pressure

    Air compressors are an integral part of any manufacturing process. Learn about the key elements that affect air-compressor performance.

    06/14/2005
  • Avoid confusion with air injection for fine powders

    Fine powders often need air injection to increase flow rates to an acceptable level. With entrained or injected air, powders flow like water, but when deaerated, the extremely low flow rate may be confused with a hang-up or arching condition.

    06/01/2005
181-200 of 243 < first | | | last >