Recover Low Level Heat, Part II

Additional innovative options exist to recover such heat

By Ven V. Venkatesan, Energy Columnist

2 of 2 1 | 2 > View on one page

Because chilled water generated from waste heat absorption chillers can enhance cooling, this concept applies to many processes where cooling towers can't lower the temperatures of process streams to required levels. One such application is the light-ends recovery from vapor streams of any fractionation column or from compressed process gas streams. If process cooling isn't critical, you definitely can substitute chilled water at the air conditioning units of the control rooms.

Installing Organic Rankine Cycle (ORC) power generating units is another innovative approach to recover low level heat. Such a unit utilizes a low boiling organic fluid as the working medium; thus, it can recover heat at much lower temperatures than practical for conventional waste-heat recovery systems. An ORC unit can use hot water as its energy source and is well established at many geothermal energy plants where hot water is naturally abundant.

In addition, because the ORC unit uses low boiling organic fluid, there's no condensation or erosion in the turbine blades compared to conventional Rankine Cycle turbines. ORC turbines are available for commercial power generation at sizes ranging from 50kW to 5MW ranges. For smaller-capacity power generating units, such as diesel generator sets, adding an ORC turbine package could generate 12–15% additional electricity for the same amount of fuel firing.

In modern dry process cement plants, even after five stages of feed preheating cyclones, the stack gases are sent into the atmosphere at temperatures of ~570°F.  The vented air from their clinker coolers also leaves at ~400°F. Because the existing heat recovery systems are limited, and no additional heat sinks are available in the cement manufacturing process, power generation from wasted low level heat is the only option. In such cases, installing an ORC power plant could be the best choice. The rejected low level heat at the kiln exhaust and cooler vent together could generate about 20% of the plant's total electricity needs.

As energy prices continue to rise and new energy efficiency standards take hold, both conventional and innovative options for low level heat recovery may gain importance.

Ven V. Venkatesan is Chemical Processing's Energy Columnist. You can e-mail him at
2 of 2 1 | 2 > View on one page
Show Comments
Hide Comments

Join the discussion

We welcome your thoughtful comments.
All comments will display your user name.

Want to participate in the discussion?

Register for free

Log in for complete access.


No one has commented on this page yet.

RSS feed for comments on this page | RSS feed for all comments